home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Tommy Walsh's DIY Guide
/
Tommy Walsh's DIY Guide (2001)(Empire).iso
/
hi
/
awruntime
/
t28b.txt
< prev
next >
Wrap
Text File
|
1998-10-08
|
4KB
|
90 lines
Summary
Power tools when properly used are extremely safe and
invaluable assets to many tasks. However, when misused
they can be very dangerous. Read and follow this
information to help minimise the risks:
1 Checking the work conditions
2 Safe tool storage
3 Using the correct tool
4 Wearing suitable clothing
5 Protecting the power cable
6 Avoid accidental switch on
7 Maintenance
8 Working outdoors
9 Stay alert!
Step 1 - Checking the work conditions
Never use power tools in damp or wet surroundings or
expose them to rain.Not only will you damage the tools
but you run the risk of electrocution.Make sure you have
adequate lighting and never use them near to combustible
fluids or gases - the spark created in electrical
motors will easily ignite combustible vapours.
Step 2 - Safe tool storage
Store your tools in a dry, locked area, inaccessible to
children. Do not let children handle the tools or the
cable and keep them away from your working area entirely.
Step 3 - Using the correct tool
Tools operate efficiently and are safer in the performance
range for which they were intended. Do not use small tools
or attachments for heavy work and never use tools for
purposes for which they were not intended. You can hire
tools for more heavy duty work quite cheaply.
Step 4 - Wearing suitable clothing
When using power-tools never wear loose fitting clothing
or jewellery, as these can become entangled in moving parts.
While working outdoors, wear rubber gloves and non-slip
footwear. Always use safety glasses and wear a breathing
mask if dust is created by the work. Ear plugs and/or ear
defenders should be used especially when drilling masonry
in a confined space.
Step 5 - Protecting the power cable
Never carry the tool by the power cable and do not use the
cable to pull the plug out of the socket. Keep the cable
protected from heat, oil and sharp edges. Remove the
plug from the socket whenever itÆs not in use, before
servicing and when changing the tool (i.e. blade, bits,
cutter, etc). Always be aware of where the cable is so
you can avoid cutting or damaging it with your tools or
work-piece.
Step 6 - Avoiding accidental switch on
Never carry tools which are still plugged in. Unplug the
tool, move it to the new location and then re-route the
power cable. NEVER carry the tool with your finger on
the power switch. Always check that the switch is in
the æoffÆ position before connecting a power tool.
Avoiding touching grounded objects such as pipes or
radiators to reduce the risk of electric shocks in
the event of an accident or tool failure.
Step 7 - Maintenance
Keep your tools clean and sharp for efficient and safe work.
Follow the maintenance regulations and instructions for the
changing of tools. Check the plug and cable regularly and
if damaged have it repaired by a qualified serviceman.
Keep the handle dry and free of grease. Never immerse your
tools in water or use solvents to clean them.
Step 8 - Working outdoors
When working outdoors use only power cables that are
intended for such use. This is because they are designed
with adequate double insulation which provides protection
against mechanical damage. The cables also have anti-splash
devices to keep them dry. It is always a good idea to use a
residual current device (RCD) - when working outdoors it can
save lives. It will cut the power instantaneously if there
is a fault condition.
Step 9 - Stay alert!
It sounds like common sense and it is. Power tools require
a high degree of concentration. If you are having problems
concentrating, stop using the tool. The best way to avoid
accidents is to take proper care.